Difference between revisions of "Robot kit"
From Fri3d WIKI 2018
(→Bedrading van de motoren) |
(→Calibrate motors) |
||
Line 47: | Line 47: | ||
: | : | ||
:; BOOT | :; BOOT | ||
− | :: Go to the next step in the progress | + | :: Go to the next step in the progress (the step you are in is visible as the number of LEDs lit in left displays) |
:; BTN0 | :; BTN0 | ||
:: Up | :: Up | ||
Line 53: | Line 53: | ||
:: Down | :: Down | ||
− | :# Choose the servo to calibrate | + | :# Choose the servo to calibrate (S0/S1/S2/S3 is shown on right display) |
− | :# Navigate the servo to the 0 degrees position | + | :# Navigate the servo to the 0 degrees position (left display shows "-", description of activity needed here!) |
− | :# Navigate the servo to the 180 degrees position | + | :# Navigate the servo to the 180 degrees position (left display shows "+", description of activity needed here!) |
− | :# Save your changes | + | :# Save your changes (with buttons select "V" on right display instead of "X" on left display) |
== Bedrading van de motoren == | == Bedrading van de motoren == |
Revision as of 10:08, 18 August 2018
Tijdens de robot presentatie (na de openingsceremonie) wordt uitgelegd hoe je de robot kit kan bouwen
Contents
Software pre-requisites
USB UART Driver https://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-drivers
Arduino IDE - https://www.arduino.cc/en/Main/Software
Visit https://github.com/Fri3dCamp/Fri3dBadge
Save as zip
In Arduino IDE: Sketch > Include Library > Add .ZIP Libarary ...
Build instructions
YouTube video met bouwinstructies: https://www.youtube.com/watch?v=ZcMtFPezIq0
- Robot body can be assembled inside out, with motors oriented wrongly
- Battery is difficult to fit, but it does fit
- Careful assembling the feet, don't push in the center, but at the sides or you risk breaking the wood
- After assembling the feet and hips and before fitting everything together, calibrate the motors
- Some examples during building:
Calibrate motors
Install calibration program
- where do I find the calibration program?
- If you have installed the Fri3dcamp library inside the arduino IDE, you can find the calibration under the following menu item:
- File > Example > Fri3d Camp Badge > 4.Kits > RobotKit > MotorCalibratie
- how to calibrate the servo's?
- Once the calibration program has been flashed on the badge, you will be able to calibrate the servo's.
- The following buttons can be used to navigate and manipulate the application:
-
- BOOT
- Go to the next step in the progress (the step you are in is visible as the number of LEDs lit in left displays)
- BTN0
- Up
- BTN1
- Down
- Choose the servo to calibrate (S0/S1/S2/S3 is shown on right display)
- Navigate the servo to the 0 degrees position (left display shows "-", description of activity needed here!)
- Navigate the servo to the 180 degrees position (left display shows "+", description of activity needed here!)
- Save your changes (with buttons select "V" on right display instead of "X" on left display)
Bedrading van de motoren
- G
- Bruin
- +
- Rood
- S
- Oranje
- 0
- Linker Enkel
- 1
- Rechter Enkel
- 2
- Linker Heup
- 3
- Rechter Heup